Are you looking for washer repair near you?
Then you are in the right place. We are Atlanta City Appliance Repair, Inc and we are located close to your house and can send our reliable technician same day or next day and fix your washer issue.
Washer repair near me - Best Washer Repair in the area
Best washer repair near me - We Repair All Major Washer Brands
GE Washer Repair
We can replace all parts on GE washers
Whirlpool Washer Repair
We can replace all parts on Whirlpool washers
Samsung Washer Repair
We can replace all parts on Samsung washers
LG Washer Repair
We can replace all parts on LG washers
Amana Washer Repair
We can replace all parts on Amana washers
Frigidaire Washer Repair
We can replace all parts on Frigidaire washers
Hotpoint Washer Repair
We can replace all parts on Hotpoint washers
Miele Washer Repair
We can replace all parts on Miele washers
Electrolux Washer Repair near me
We can replace all parts on Electrolux washers
Washer Repair Near me - All washer parts replacement near me
- Motors replacement
- Control panel replacement
- Belts replacement
- Transmission replacement
- Timers replacement
- Water pressure switch replacement
- Lid switch replacement
- Suspension rods/bearing replacement
- Water sensors replacement
- Pumps replacement
- Relays replacement
- Water valve replacement
- Actuator replacement
- Washer seal(rubber) replacement
- All hoses(hot/cold water) replacement
- Unclogging/Cleaning drain pumps
Washer most common issues - Best Washer Service near me
IT DOESN’T WORK AT ALL
- No power to the washer
Make sure there’s power getting to the washer. Check for a tripped circuit breaker or a blown fuse. Check the wall socket for power. Sometimes the power cord disconnects at the washer, if this is the case, the wiring must be repaired or replaced.
- Lid switch
The washing machine may not function if the lid switch is defective. The switch is usually located near the door. Replace if found defective.
IT FILLS AND DRAINS AT THE SAME TIME
- Drain hose
The drain hose might be too low. Make sure the drain hose is at least three feet above the floor.
- Clogged drain line or water pump
Check to see if there’s something stuck inside the pump or the drain hose connected to the pump (pump is usually located at the bottom and towards the back of the washing machine).
- Water Pump
If the drain line isn’t clogged, you may have a problem with the water pump such as a frozen pulley or a broken impeller. If that’s the case replace the water pump. Note: if you have a belt driven washer, check the belt(s) for cracks, as this would be a perfect time to replace the belt(s) if needed.
IT DOESN’T DRAIN
- Lid switch assembly
If the washer will not drain a very common issue is that the lid switch assembly has malfunctioned. The lid switch can fail either mechanically or electrically and should be tested with an ohm meter for continuity. If the part has failed it will need to be replaced.
- Drain pump or hose
If the lid switch assembly is functioning, the next thing to check for is a clogged pump or hose. Small clothing (especially baby clothing or socks) can get sucked into the drain system and clog the hose that leads to the pump, or even the pump itself. You can also check to see if there is a kink in the hose and check the functionality of the drain pump. When removing the hoses to check for obstructions, keep in mind that any water remaining in the washer will flow out when the hoses are removed. Therefore it is good to have towels prepared in case this happens.
- Water pump belt
If there is no obstruction in the pump or hose, the next thing to check is the water pump belt. These belts wear out and break over time, and will need to be replaced if broken or showing excessive wear.
- Drive belt
If the washer is still not draining, the next thing to check is the drive belt. If this belt is worn, broken, or not on the pulley system, the washer will possibly not drain at all. If the belt has excessive wear or is broken it will need to be replaced.
- Coin trap
If the washer is not draining and everything is functioning, the final thing to check is the coin trap. This device is located near the water pump and it catches any foreign materials that make their way down the drain. This part often has an access panel and can normally be cleaned very easily.
NO HOT WATER
Make sure the hot water is turned on.
NO COLD WATER
Make sure the cold water is turned on.
THERE IS NO WATER AT ALL
First, make sure there’s water getting to the washing machine.
Water Inlet Valve
Replace if found defective.